Lynxmotion Tech Support

Does anyone have the exact location of the Servo shaft (horn) for a hitec 645mg in relation to the casing??

thank you.

_________________
Jonny Poole,
Freelance Concept Art & Animatronics, 3D Art and 3D Modelling, as well as Physical Modelling, Mechanical design, and illustration.
http://www.innerbreed.co.uk/
Create, Innovate, Inspire.

Contacted Hitec. We'll post here when we get the information.

_________________
Coleman Benson
Lynxmotion
Imagine it. Build it. Control it.™
http://www.Lynxmotion.com

That's a nice GraveDigging ...!
Would be real nice since to know

_________________
Eric Nantel
Qc Canada

Always liked Robot... Now i am learning to make some...! Wonderfull...

... and unfortunately the techs at Hitec don't seem to have that information. It will need to be lifted from the dimensional drawing assuming it's to scale.
http://www.robotshop.com/PDF/hs645mg.pdf

_________________
Coleman Benson
Lynxmotion
Imagine it. Build it. Control it.™
http://www.Lynxmotion.com

Maybe the supplier of your aluminum horns?

_________________
Eric Nantel
Qc Canada

Always liked Robot... Now i am learning to make some...! Wonderfull...

I guess I'll stick to the 16.5mm from edge of servo tab, that I've been using then.

_________________
Jonny Poole,
Freelance Concept Art & Animatronics, 3D Art and 3D Modelling, as well as Physical Modelling, Mechanical design, and illustration.
http://www.innerbreed.co.uk/
Create, Innovate, Inspire.

For the 645MG, we measured 30.5mm from the edge of one side and 10.1mm from the other. According to the printout, it's 30.7 from one side, which would make it 9.9 from the other. There is a bit of play when you connect the servo to a bracket. The metal horn manufacturer does not have the data for the servo - just the horn.
http://www.robotshop.com/PDF/hs645mg.pdf

_________________
Coleman Benson
Lynxmotion
Imagine it. Build it. Control it.™
http://www.Lynxmotion.com

Yes I've got those measurements. Seeing that I measured from the edge of the tabs, (adding 6.5mm) then your measurements confirm the horn placement of 9.9mm from case edge, or 16.5mm from tab edge 'give or take .3 as my caliper is bust! Lol

_________________
Jonny Poole,
Freelance Concept Art & Animatronics, 3D Art and 3D Modelling, as well as Physical Modelling, Mechanical design, and illustration.
http://www.innerbreed.co.uk/
Create, Innovate, Inspire.