Lynxmotion Tech Support

www.lynxmotion.com		 Join the Accelerator Program
It is currently Wed Jun 19, 2013 3:37 pm

View unanswered posts | View active topics


Board index » Robots » Servo Erector Set

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
A Cute Angle
 Post subject: Microrax overview needed
PostPosted: Mon Aug 20, 2012 4:39 pm 
Offline
Roboteer

Joined: Mon Aug 20, 2012 3:38 pm
Posts: 3
An overview of Microrax is needed. It took me a while to figure out which parts might fit where. I think that I now know where they go. Dual nut plates in the track, screw through a joining plate, and screw heads are outside. I don't know if joining plates can be stacked with standard screws or not.
Top
 Profile  
 
Robot Dude
PostPosted: Mon Aug 20, 2012 4:42 pm 
Offline
Lynxmotion Founder
User avatar

Joined: Mon Oct 31, 2005 10:46 am
Posts: 9325
Location: my quiet place
No as you might imagine there is very little spacing between the screw and the extrusion connecting a single plate. The 5mm screws are perfect for a single plate. If you stack plates you will need a longer screw.

_________________
Jim Frye, the Robot Guy
http://www.lynxmotion.com
I've always tried to do my best...
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Robots » Servo Erector Set

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group